Ensure all leads and electrical connections to the solar module junction boxes are made prior to assembling Roof Mount Kit

ALZONE Roof Mount Kits are the only Roof Mount Kit certified to withstand the most severe cyclone areas in Australia (Region D). Special Corrugated Feet are available for installation on corrugated iron roofing. Many different styles of mounting kits are available including portrait and landscape orientation. For further information please visit the web site at www.alzone.com.au. To order, please fill in the order form on the opposite page.

Place all mounting Feet in their preferred position on roof so they are aligned with roof beams. Position Standard Rails so that Mid Slots face the centre. Slide Stainless Bolts SPMP3825, into the Mid Slot of the Standard Rail and attach Feet with two Stainless Bolts SPMB3825 per Foot. Feet are positioned on the inside of the Standard Rail.

When all Feet and Standard Rails are in position the Mounting Kit is checked, and made square. At this stage the Mounting Feet may be fastened to the roof.

Please Note: Dissimilar metals must be separated to avoid corrosion. A suitable membrane should be used to between any dissimilar metals.

Insert two “T” Bolts with End Clamps into the Edge Slot of the Standard Rail at the position where the first or lowest solar module will be installed. Then position the first solar module and tighten the End Clamps.

Slide one “T” bolt into the Edge Slot of each Standard Rail and then position the second solar module.

Attach Middle Clamps and nuts to “T” bolts between module 1 and 2 and tighten.

Repeat steps 5 and 6 until all solar modules for the kit are in place.

When the last module is in position, insert a “T” Bolt into the Edge Slot of each Standard Rail Edge Slot. Attach End Clamps and tighten nuts to secure the final module in position.

Check that all rail kit bolts and clamps are tight and all solar modules and Standard Rails are square.